In setting up the Wilson Wheel Corral you change the angle of the rear wheels with the turn levers on top of the unit, this puts the unit into field position. 

As you drive forward the unit will automatically open out to a Y position of standard width.  This allows clearance for all the panels to unfold.   You change these levers on each side then drive forward approximately 60 feet.    When the unit is completely opened up stop your vehicle.

Release the lever behind the cage by first pushing inward and slightly move lever away from the hook.  DO NOT LOOSEN GRIP ON THE LEVER AS THE PRESSURE IS LESSONED ON THE LEVER AS EARLY RELEASE CAN CAUSE SERIOUS BODILY INJURY.  Slowly raise the lever enough to disconnect the chain, which will be putting your #2 panel on a 18 inch tire on the ground.  Manually roll this panel into place at about a 140 degree angle.  Each panel is double hinged for unleveled ground, they will flex up and down and sideways at the same time yet the panel remains straight up and down.

Putting the #2 panel into position bumping the 11L15 tire you release the next lever placing the #3 panel on a 13 inch tire on the ground.  As you walk by the outriggers pull the pins and swing them out.  The outriggers are designed to allow the livestock to push on the panels, the more they dig in the stronger the unit gets.  Now showing the #3 panel rolling back on a 13-inch tire.  Next go to the inside, lift the #4 panel off the steel peg putting the panel on the ground on a caster wheel.  Roll the #4 panel into position.  The number three outriggers should not be set until the livestock are inside the corral.

If you need to change the size of the corral, it is much easier to change with the third outrigger not placed to accommodate the size that is needed.  The unfolded corral measures 80’ in panel length along each side.

Go to the opposite side and repeat the same process stated above

Two thirds of the way back on the first panel is a 14’ crowding gate, divide gates are on the inside of the corral, the one on the left is 16 feet behind the cage, and the one on the right is 16 feet behind the cage.  Bring the sorting gates to the center of the corral and chain them together then open the 10 fort crowding gate.  A 6-foot divide gate is at the back of the cage.